- whatsapp +51955515985
- support@ecuforcetruck.com
- 24/7 Customer Support
Menu
Shop
Account
Subtotal: $0.00
No products in the cart.
Circuit Description
The engine control module (ECM) provides a 5 volt supply to the intake manifold pressure sensor on the sensor supply circuit. The ECM also provides a ground on the sensor return circuit. The intake manifold pressure sensor provides a signal to the ECM on the intake manifold pressure sensor signal circuit. This sensor signal voltage changes, based on the pressure in the intake manifold.
The ECM uses the intake manifold pressure reading to monitor turbocharger performance.
Component Location
The turbocharger is mounted to the exhaust manifold.
Conditions for Running the Diagnostics
This diagnostic must meet specific engine and aftertreatment conditions to run and complete
Conditions for Setting the Fault Codes
The ECM detects that the variable geometry turbocharger (VGT) actuator is slow to meet commanded position.
Action Taken When the Fault Code is Active
The ECM illuminates the amber CHECK ENGINE lamp and/or malfunction indicator lamp (MIL) after the diagnostic fails on two consecutive trips.
Conditions for Clearing the Fault Code
To validate the repair, start the engine and let it idle for 5 minutes.
To validate the repair using a Diagnostic Road Test, utilize a route that incorporates both stop-and-go city driving and steady state highway driving. It may be necessary to load the unit for certain diagnostics in the ECM to run.
To validate the repair using a Chassis Dynamometer Test, utilize a routine that incorporates acceleration and motoring events, steady-state highway operation, and load. This will simulate normal driving and allow the diagnostics in the ECM to run.
The fault code status displayed by INSITE? electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.
The ECM will turn off the amber CHECK ENGINE lamp after the diagnostic runs and passes.
For On-Board Diagnostics (OBD) engines, the ECM will turn off the MIL after three consecutive trips where the diagnostic runs and passes.
The ?Reset All Faults? command in INSITE? electronic service tool can be used to clear active and inactive faults, as well as extinguish the MIL for OBD applications.
Shop Talk
Possible causes of this fault code include:
A malfunctioning VGT
High exhaust restriction.
Possible Cause:
1) Turbocharger failure
2) VGT actuator failure
3) ECM calibration
Related
Categories Cumminz, DTC TRUCKS, ISX15 CM2250 (2010-12)Tags 1, 10, 102, 2010-12, 3361, Abnormal, Change, CM2250, Code, Cummins, Fault, FMI, Intake, ISX15, Manifold, of, PID, Pressure-, Rate, SPN
Wiring Diagrams
Component Locators
- Volvo Penta EPC 6 Offline VMware [12.2021] VMware
Trucks software$64.00
Rated 0 out of 5
- Perkins EST 2021B v1.0 Active License + FPKG ( 1 PC )
CAT$75.00
Rated 0 out of 5
- Diamond Logic Builder DLB 2019 Database 2019
Navistar$50.00
Rated 0 out of 5
- JPRO 2022 v3 ( 1 PC )
JPRO$94.00
Rated 0 out of 5
- Perkins EST 2022A ( 1 PC )
Perkins$86.00
Rated 0 out of 5
Related products
1000 & 2000 Gen 4$50.00
Rated 0 out of 5
1000 & 2000 Gen 4$50.00
Rated 0 out of 5
1000 & 2000 Gen 4$50.00
Rated 0 out of 5
1000 & 2000 Gen 4$50.00
Rated 0 out of 5
1000 & 2000 Gen 4$50.00
Rated 0 out of 5
1000 & 2000 Gen 4$50.00
Rated 0 out of 5
1000 & 2000 Gen 4$50.00
Rated 0 out of 5
1000 & 2000 Gen 4$50.00
Rated 0 out of 5
1000 & 2000 Gen 4$50.00
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3634 PID: SPN:5484 FMI:4 Engine Fan Clutch 2 Control Circuit – Voltage Below Normal or Shorted to Low Source
DTC TRUCKS
Rated 0 out of 5
1000 & 2000 Gen 4$50.00
Rated 0 out of 5
1000 & 2000 Gen 4$50.00
Rated 0 out of 5
1000 & 2000 Gen 4$50.00
Rated 0 out of 5
1000 & 2000 Gen 4$50.00
Rated 0 out of 5
1000 & 2000 Gen 4$50.00
Rated 0 out of 5
- SERVICE MANUAL HINO FD.FE.FF.SG 2015
HINO$35.00
Rated 0 out of 5
- SERVICE MANUAL BOBCAT 130 sms
BOBCAT$52.00
Rated 0 out of 5
- SERVICE MANUAL DDEC VI Troubleshooting Guide – MBE4000 6SE568
DETROIT$40.00
Rated 0 out of 5
- SERVICE MANUAL DETROIT 1995 SER 60 PARTS
DETROIT$65.00
Rated 0 out of 5
- SERVICE MANUAL DETROIT DIESEL DDEC III – IV Master 2000 Training
DETROIT$25.00
Rated 0 out of 5
- SERVICE MANUAL Carrie Supra 644 744 844
CARRIE$20.00
Rated 0 out of 5
- SERVICE MANUAL BOBCAT 600, 600D, 610, 611
BOBCAT$65.00
Rated 0 out of 5
- SERVICE MANUAL Fuso FH Series 2002-2004
FUSO$29.00
Rated 0 out of 5
- SERVICE MANUAL VOLVO D13 (2009)
TRUCK MANUALS$25.00
Rated 0 out of 5
FUSO$30.00
Rated 0 out of 5